The automatic loading mixer not only has the function of transporting soil, but also has the function of mixing soil. Because of the characteristics of soil, it will dry after a short time, so it can be mixed all the time. The mixing of soil requires a mixing shaft. How to solve the problem if the mixing shaft stops rotating during operation?

自动上料搅拌车

Automatic feeding mixer

一、自动上料搅拌车搅拌轴停止转动的原因

1、 The reason why the mixing shaft of automatic feeding mixer stops rotating

1、电机传动皮带有没有出现松动的情况？

1. Is the motor drive belt loose?

自动上料搅拌车电机传动皮带过松也能导致商品混凝土拌合机搅拌轴转动缓慢或者停止转动，电机传动皮带过松，导致传递的动力不足。

The motor drive belt of the automatic feeding mixer truck is too loose, which can cause the mixing shaft of the commercial concrete mixer to rotate slowly or stop rotating, and the motor drive belt is too loose, resulting in insufficient power transmission.

2、搅拌叶片或侧叶片与筒体内壁间有没有大的异物？

2. Is there any large foreign matter between the mixing blade or side blade and the inner wall of the cylinder?

出现这种情况也会使搅拌车搅拌轴停止转动或转动缓慢。搅拌叶片或侧叶片与罐内壁间有较大的异物也会导致搅拌轴停转，之所以能卡存异物，由于搅拌叶片或侧叶片与罐内壁间隙过大造成的。尤其是石子。

In this case, the mixing shaft of the mixer truck will stop or rotate slowly. The large foreign matter between the mixing blade or side blade and the inner wall of the tank will also cause the mixing shaft to stop rotating. The reason why the foreign matter can be stuck is due to the large gap between the mixing blade or side blade and the inner wall of the tank. Especially stones.

二、自动上料搅拌车搅拌轴停止转动该如何

2、 How to solve the problem that the mixing shaft of automatic feeding mixer stops rotating

1、自动上料搅拌车电机传动皮带过松的情况，只需停机后调整混凝土搅拌机电机传动皮带的张紧度即可。

1, automatic feeding mixer motor transmission belt loose condition, just stop after adjusting the concrete mixer motor drive belt tension degree can be.

2、侧叶片与关内壁卡滞物料时，在搅拌轴停转前往往会有尖锐刺耳的摩擦声，出现这种情况立即停机检查，人工排除异物，重新调整混凝土自动上料搅拌车搅拌叶片或侧叶片与罐内壁间的间隙，有必要时可以用水先清洗下。

2. When materials are stuck between the side blade and the inner wall of the closing wall, there is often a sharp and harsh friction sound before the mixing shaft stops running. In this case, stop the machine immediately for inspection, remove foreign matters manually, and readjust the gap between the mixing blade or the side blade and the inner wall of the tank of the automatic concrete feeding mixer truck. If necessary, clean it with water first.

自动上料搅拌车的消耗很大，既要运输又要搅拌泥土的作用，那么尤其是它的搅拌轴一定要及时检查，正常情况下随着车的运行搅拌轴不断转动。如果停止转动，及时查找原因并。

Under the condition of mixing truck, it is necessary to check the normal operation of the mixer shaft. If it stops rotating, find out the cause and solve it in time.

以上就是有关自动上料搅拌车的相关问题了，希望对您有所帮助。

The above is about the automatic feeding mixer related issues, I hope to help you.