On the surface, it's easy to clean the center console of the automatic feeding mixer with a piece of cloth. In fact, if you pay a little attention to it, you will find that there are many "gullies" in the dashboard that need special tools.

这时候，可以找一些不同厚度的木片或尺子，将其一端修成三角等较尖的样式，然后包在干净的抹布里进行清理。比如说自动上料搅拌车空调送风口的百叶部分，用普通抹布很难清理到位，但如果用抹布包上一把尺子，就很容易完成了。

At this time, you can find some pieces of wood or ruler with different thickness, trim one end into a triangle and other sharp style, and then pack it in a clean rag for cleaning. For example, the louver part of the air-conditioning air supply outlet of the automatic feeding mixer is difficult to clean with ordinary rags, but if a ruler is wrapped with rags, it is easy to complete.

1、 常被遗忘的点火线

1. Often forgotten ignition wire

火花塞大家都很熟悉了，但点火线却经常被大家遗忘。当自动上料搅拌车出现不容易着火、油耗增加、动力差等症状时，建议检查一下点火线。点火线两端分别连接分电器和火花塞，是传递给自动上料搅拌罐发动机电火花的路径。

We are all familiar with the spark plug, but the ignition wire is often forgotten. When the automatic feeding mixer is not easy to fire, fuel consumption increases, poor power and other symptoms, it is recommended to check the ignition line. Both ends of the ignition wire are respectively connected with the distributor and the spark plug, which is the only way to transmit the spark to the automatic feeding mixing tank engine.

由于其使用频率高，工作环境也比较恶劣，会很容易出现老化、破损等现象，造成点火能量不足。建议，自动上料搅拌罐每两万更换点火线。

Because of its high frequency of use and bad working environment, it is easy to appear aging, damage and other phenomena, resulting in insufficient ignition energy. Experts suggest that the ignition line of automatic feeding mixing tank should be replaced every 20000 km.

2、刹车盘也需要关注

2. Brake discs also need attention

目前越来越多的自动上料搅拌车都逐渐从前盘后鼓的制动配置向前盘后盘的配置过渡，采用盘式刹车的好处在于散热更好，清理和更换更加方便。多数司机认为，刹车片比刹车盘更容易磨损，事实上盘与片的作用力都是相互的，接触摩擦都会有磨损。

At present, more and more automatic feeding mixers are gradually transiting from the brake configuration of front disc and rear drum to the configuration of front disc and rear disc. The advantages of using disc brake are better heat dissipation and more convenient cleaning and replacement. Most drivers think that the brake pads are easier to wear than the brake discs. In fact, the forces between the discs are mutual, and there will be wear in contact friction.

另外自动上料搅拌车刹车盘表面比刹车片光滑，容易受刹车片粗糙表面的影响。所以在检查更换刹车片的同时，也要注意自动上料搅拌车刹车盘表面的状况，如果出现比较清晰的划痕，建议更换新的自动上料搅拌车刹车盘，以免后患。

In addition, the surface of the brake disc of the automatic feeding mixer is smoother than that of the brake pad, which is easily affected by the rough surface of the brake pad. Therefore, when checking and replacing the brake pads, it is also necessary to pay attention to the surface condition of the brake disc of the automatic feeding mixer. If there are relatively clear scratches, it is recommended to replace the brake disc of the automatic feeding mixer to avoid future trouble.