If the brake cylinder of the automatic mixing truck leaks brake fluid or the cylinder pipeline is broken, use iron sheet and copper sheet as a small cushion at the cylinder pipeline joint to block the pipeline, and then tighten the screw, or clamp the fracture flat and curl to block the leakage, so that the wheel can not be used for braking. But doing so may cause unilateral braking. Pay attention to safety when driving.
The brake fluid of the mixer is not available for brake fluid, and can be replaced by alcohol or baijiu. When the brake cup of the automatic mixer truck rises, soak the rising cup in hot water for 10-20 minutes, and remove the oil content from the cup, so that the cup can return to its original size.
The friction plate of mixer clutch is ablated and skidded. The friction plate with less serious ablation can be turned over. If the ablation is serious, several layers of cotton cloth or canvas can be used (its thickness should be consistent with the original friction plate), and steel wire or iron wire can be used to pass through the hole on the steel plate to fix it. When driving the automatic mixer truck, the starting shall be stable and the shifting action shall be rapid.
Use a hammer to replace the broken part of the steering knuckle screw on the steering knuckle assembly, which is similar to the broken part of the steering knuckle or the broken part of the automatic bumper.
If the differential gear of the three axle automatic mixer is damaged, if either the middle and rear axle differential is damaged, the transmission shaft and half shaft of the axle can be removed, and the automatic mixer continues to drive. If the front differential is damaged, remove the hub adapter of the automatic mixing wheel and continue driving.