修复自动上料小型搅拌车驱动系统有哪些方法？

What are the methods to repair the drive system of automatic feeding small mixer?

自动上料小型搅拌车的大多数混合操作是机械混合，主要使用中低压立式钢制容器作为混合设备来了解问题：

Most of the mixing operation of the automatic feeding small mixer is mechanical mixing. The medium and low pressure vertical steel containers are mainly used as mixing equipment to understand the problems

压紧驾驶员后，卸下驾驶员软管并收回两辆车。关闭自动上料小型混凝土搅拌车，拆下其液压马达的高压燃油管，在支撑辊和滚道之间放置一个木楔，然后将发生故障的相应接头放在卡车上，并使用紧密驱动的软垫其位置。相应的关节控制搅拌筒的旋转。

After compressing the driver, remove the driver hose and retract both vehicles. Close the automatic feeding small concrete mixer, remove the high-pressure fuel pipe of its hydraulic motor, place a wooden wedge between the support roller and the raceway, and then place the corresponding joint with failure on the truck, and use the tightly driven cushion to its position. The corresponding joint controls the rotation of the mixing drum.

请注意，关闭发动机，拆除液压马达的高压油管，搅拌箱可以自由旋转，控制搅拌箱的旋转，将维护孔转到下部，然后打开维护孔并清洗混凝土在气缸中。这时，您必须注意性。卸载混凝土后，进料搅拌机返回到其原始状态。

Please pay attention to safety, shut down the engine, remove the high pressure oil pipe of the hydraulic motor, the mixing tank can rotate freely, control the rotation of the mixing tank, turn the maintenance hole to the lower part, and then open the maintenance hole and clean the concrete in the cylinder. At this point, you must pay attention to security. After unloading the concrete, the feed mixer returns to its original state.

启动自动上料小型搅拌车并将其操作手柄置于卸载位置，有缺陷的混凝土将被卸出。准备紧紧驱动软管，关闭自动加载混合器，并卸下液压马达上的高压燃油管接头。

Start the small automatic loading mixer and put its operating handle in the unloading position, and the defective concrete will be discharged. Prepare to tighten the drive hose, close the autoloader mixer, and remove the high pressure fuel line fitting from the hydraulic motor.

修复自动上料小型搅拌车驱动的方法你学会了吗？

Have you learned how to repair the drive of automatic feeding small mixer?