Even if the mechanical equipment is used for a long time, it needs to be refueled from time to time to maintain good operation performance. So what should be paid attention to when adding lubricant to the equipment?

1.在操作过程中，请勿对搅拌一体车进行大修和润滑。

1. Do not overhaul or lubricate the automatic feeding mixer during operation.

2.定期在每个注油嘴中注满润滑脂，每4小时向轴端密封圈涂抹润滑脂，并每周排放一次污水。

2. Fill grease in each nozzle regularly, apply grease to shaft end sealing ring every 4 hours, and discharge sewage once a week.

3.使用自动供料搅拌器后，根据需要在每个润滑点添加所需的润滑油（辊轴，辊，钢丝绳和其他运动部件）。

3. After using the automatic feeding agitator, add the required lubricating oil (roller shaft, roller, wire rope and other moving parts) at each lubricating point as required.

4.搅拌一体车减速器齿轮箱中的齿轮和轴承利用齿轮旋转将油撒到箱体的内壁上，并流入轴承中进行润滑。变速箱中的油位应保持在油尺上的两条刻线之间。如果油位过高或过低，每个零件的温度都会升高，润滑会不足，从而导致功率损耗增加，机器运行速度变慢。

4. The gear and bearing in the gearbox of the mixer truck use the gear rotation to scatter the oil on the inner wall of the gearbox and flow into the bearing for lubrication. The oil level in the transmission should be maintained between the two lines on the dipstick. If the oil level is too high or too low, the temperature of each part will rise and the lubrication will be insufficient, which will increase the power loss and slow down the running speed of the machine.

5.为自动供料混合器选择的润滑油必须不含比粘度和粘度-温度特性，低凝固点，良好的氧化稳定性，机械杂质和水分以及腐蚀和磨蚀性物质。其质量指标必须符合标准。

5. The lubricating oil selected for the automatic feed mixer must be free of specific viscosity and viscosity temperature characteristics, low freezing point, good oxidation stability, mechanical impurities and moisture, and corrosive and abrasive substances. Its quality index must conform to the national standard.

润滑自动进料混合器可有效减少磨损并延长组件寿命。但是，在添加润滑油的过程中需要注意一些事项，在新机器的前150个小时和300个小时应更换一次润滑油，以去除在测试运行期间未完全清洁的污垢。在工作期间，应经常检查油位以弥补时间不足。

Lubrication of the automatic feed mixer can effectively reduce wear and prolong the service life of the components. However, in the process of adding lubricating oil, it is necessary to pay attention to some matters. In the first 150 hours and 300 hours of the new machine, the lubricating oil should be replaced to remove the dirt that is not completely cleaned during the test run. During the working period, the oil level should be checked frequently to make up for the lack of time.

搅拌一体车添加润滑油的注意事项，希望对您有帮助！如想要了解更多的精彩内容请关注：http://www.jfhntjbj.com会有为大家呈现更多的精彩内容。

Notice of adding lubricating oil to mixer truck, hope to help you! For more details, please pay attention to: http://www.jfhntjbj.com There will be more wonderful content for you.