It's very hot in summer. The internal noise and temperature of 6-square self feeding mixer are very high. The low temperature in summer may be caused by the temperature of engine and oil.

1.洗车池中的水量不足。加水到洗车池。

1. There is not enough water in the car wash pool. Add water to the car wash.

2.如果吸管的吸口被阻塞或堵塞，则可以检查并拧紧吸管。

2. If the suction port of the straw is blocked or blocked, check and tighten the straw.

3.如果燃油箱中的油位过低并且油位中的空气已泵入泵中，则可以添加具有相同标签的液压油。

3. If the oil level in the fuel tank is too low and the air in the oil level has been pumped into the pump, the hydraulic oil with the same label can be added.

4.如果泵安装支架的刚性不足，并且在工作过程中发生振动或噪音，则可以加固油泵安装支架。

4. If the rigidity of the pump mounting bracket is insufficient, and vibration or noise occurs in the working process, the pump mounting bracket can be reinforced.

5.如果滤芯堵塞，则可能很难或不可能完全吸收机油。在这种情况下，可以清洁或更换滤芯。

5. If the filter element is blocked, it may be difficult or impossible to completely absorb the oil. In this case, the filter element can be cleaned or replaced.

6.油冷却风扇未打开。方案：打开冷却风扇。

6. The oil cooling fan is not turned on. Solution: turn on the cooling fan.

7.如果液压油不符合要求或油的粘度太高，请更换符合标签要求的低粘度液压油。

7. If the hydraulic oil does not meet the requirements or the viscosity of the oil is too high, please replace the low viscosity hydraulic oil that meets the label requirements.

8.储罐中有坚硬的混凝土。如果发生这种情况，请及时清理并铲起。

8. There is hard concrete in the tank. If this happens, clean up and shovel in time.

9.如果输入法兰与万向传动轴之间的连接角度以及万向传动轴与取力器之间的连接角度太大，则松动时会产生噪音。如果发生这种情况，请及时检查并拧紧。

9. If the connection angle between the input flange and the cardan drive shaft and the connection angle between the cardan drive shaft and the power take-off are too large, noise will be generated when it is loose. If this happens, please check and tighten in time.

6方自上料搅拌车温度高引起的原因你都了解了吗？更多精彩内容直接关注：http://www.jfhntjbj.com

Do you understand the causes of high temperature in 6-way self feeding mixer? Direct attention to more highlights: http://www.jfhntjbj.com