欢迎来到中科聚峰机械有限公司!

24小时服务热线:

400-879-1999

点击拨打服务热线:400-879-1999
当前位置:首页>新闻中心>行业新闻搅拌一体车工作后注意事项有哪些?

搅拌一体车工作后注意事项有哪些?

来源:http://www.jfhntjbj.com/ 日期:2021-05-27 发布人:admin
概述:一般操作或是使用过混凝土搅拌机的用户都知道一些有关于混凝土搅拌机工作后注意事项,按照所需注意的事项操作会让搅拌车在能更得心应手。以下与您分享搅拌一体车工作后注意事项有哪些
一般操作或是使用过混凝土搅拌机的用户都知道一些有关于混凝土搅拌机工作后注意事项,按照所需注意的事项操作会让搅拌车在能更得心应手。以下与您分享搅拌一体车工作后注意事项有哪些?
General operation or users who have used the concrete mixer all know some matters needing attention after the concrete mixer works. The operation according to the matters needing attention will make the mixer more handy. What should be paid attention to after the mixer works?
1、搅拌一体车停工后用水和石子倒入搅拌筒内10-15分钟进行清洗,再将水和石子清出。操作人员如须进入搅拌筒内清洗时。除切断电源和卸下熔断器外,并须锁好开关箱。
1. After the mixing truck stops, pour water and stones into the mixing drum for 10-15 minutes for cleaning, and then remove the water and stones. If the operator has to enter the mixing drum for cleaning. In addition to cutting off the power supply and removing the fuse, the switch box must be locked.
2检查机械各部件(如马达、钢丝绳、轴承、刹车、离合器等),如有不正常现象时,应立即进行修理或更换。
2 check all parts of the machine (such as motor, wire rope, bearing, brake, clutch, etc.) and repair or replace them immediately if there is any abnormal phenomenon.
搅拌一体车
3、搅拌一体车工作完毕后,应将料斗落降到基坑中,如需升起则应用链条扣牢,保证料斗落不下来。
3. After the mixer truck is finished, the hopper should be lowered into the foundation pit. If it needs to be raised, the chain should be used to fasten it to ensure that the hopper can not fall down.
4、严禁用大锤打的方法清 除积存在搅拌一体车筒内的混凝土,只能用凿子清 除。
4. It is strictly forbidden to remove the concrete accumulated in the drum of the mixer truck by hammering, but only by chisel.
5、搅拌一体车停车后应将电门开关箱加锁,并罩好电动机。
5. The switch box should be locked and the motor should be covered after the truck stops.
6、搅拌一体车在严寒季节,工作完毕后应用水清洗搅拌机滚筒并将水泵、水箱、水管内积水放净,以免冻坏。
6. In the severe cold season, the mixer drum should be cleaned with water after work, and the water in the water pump, water tank and water pipe should be drained to avoid freezing.
7、搅拌车进行保养规程所规定项目的维护、保养作业,如清洗、润滑、加油等。
7. The mixer shall carry out the maintenance of the items specified in the maintenance regulations, such as cleaning, lubrication, refueling, etc.

截屏,微信识别二维码