欢迎来到中科聚峰机械有限公司!

24小时服务热线:

400-879-1999

点击拨打服务热线:400-879-1999
当前位置:首页>新闻中心>行业新闻搅拌一体车散热器不转或转不停怎么办

搅拌一体车散热器不转或转不停怎么办

来源:http://www.jfhntjbj.com/ 日期:2022-09-07 发布人:admin
概述:相信对于有过多年卡车经验的老司机来说,车上一些简单的故障只要动动手指就处理好了。但也有些搅友遇到问题就进场维修也难免遇坑,下面小编
相信对于有过多年卡车经验的老司机来说,车上一些简单的故障只要动动手指就处理好了。但也有些搅友遇到问题就进场维修也难免遇“坑”,下面小编来讲讲搅拌一体车散热器不转或转不停要怎么办。
I believe that for the old driver who has many years of truck experience, some simple faults on the car can be solved by moving his fingers. However, some agitators will inevitably encounter "pits" when they enter the site for maintenance when they encounter problems. The following editor will talk about what to do if the radiator of the integrated mixer does not rotate or does not stop.
①检查散热器保险是否损坏;如果是,则需更换保险丝;
① Check whether the radiator fuse is damaged; If yes, replace the fuse;
②检查散热器温控感应塞是否损坏;如果是,则需更换温控感应塞;
② Check whether the temperature control sensing plug of radiator is damaged; If yes, replace the temperature control sensing plug;
③检查散热器风扇电机是否损坏;如果是,则需更换电机;
③ Check whether the radiator fan motor is damaged; If yes, replace the motor;
④检查线路是否断路或虚接,如果是,则需检查更换线路。
④ Check the circuit for open circuit or virtual connection. If so, check and replace the circuit.
此外还有几个问题要了解,比如:
In addition, there are several questions to understand, such as:
拖轮异响
Abnormal sound of tugboat
①检查拖轮的保养情况,检查拖轮及轨道面是否有杂物;
① Check the maintenance of the tugboat and check whether there are sundries on the tugboat and the track surface;
②检查拖轮与轨道间是否存在间隙,可调整拖轮与轨道面相关角度;
② Check whether there is a gap between the tugboat and the rail, and adjust the angle between the tugboat and the rail surface;
搅拌一体车
③查内部轴承是否损坏;
③ Check whether the internal bearing is damaged;
④缺黄油。
④ I'm short of butter.
后操纵手柄重
Rear joystick (heavy)
①拉杆支架缺黄油;
① The tie rod bracket is short of grease;
②连接球头有无松动。
② Check whether the connecting ball joint is loose.
6、室内控制器手柄操作重
6. Heavy operation of indoor controller handle
①检查室内控制器拉线是否卡死,角度是否过大;
① Check whether the indoor controller cable is stuck and whether the angle is too large;
②检查拉线包皮有无磨损;
② Check whether the cable sheath is worn;
③检查限位螺母是否松动。
③ Check whether the limit nut is loose.
如果您有任何有关搅拌车的问题,可致电咨询我们http://www.jfhntjbj.com,定竭力为你解答。
If you have any questions about the mixer, please call us http://www.jfhntjbj.com Yes, I will try my best to answer for you.

截屏,微信识别二维码