欢迎来到莱州中科聚峰机械有限公司!

24小时服务热线:

15053524111

点击拨打服务热线:15053524111
热门关键词: 自动搅拌车,自动上料搅拌车,搅拌一体车
当前位置:首页>产品中心>平口搅拌车>1.2方平口搅拌车

1.2方平口搅拌车

来源:http://www.jfhntjbj.com/ 日期:2021-03-22 发布人:guanli浏览:

1.它由动力输出装置,万向轴,液压泵,液压马达,控制阀,液压油箱和冷却系统组成普通车削零件是有缺陷的零件。润滑脂应按时加注,应经常检查磨损并及时修理和更换。团队必须有一个备用的万向轴组件,以便万一发生故障,几分钟之内即可将其恢复。
1. It consists of power take-off, cardan shaft, hydraulic pump, hydraulic motor, control valve, hydraulic oil tank and cooling system. Ordinary turning parts are defective parts. The grease should be filled on time, the wear should be checked frequently, and the grease should be repaired and replaced in time. The team must have a spare cardan shaft assembly so that it can be restored in a few minutes in case of failure.
2.确保液压油清洁。混凝土搅拌车的工作环境不好,必须防止脏的水泥砂进入液压系统。应根据手册的要求定期更换液压油。如果检查发现液压油被水或沙子污染,则应立即停止液压系统并更换液压油。
2. Make sure the hydraulic oil is clean. The working environment of concrete mixer is not good, so it is necessary to prevent the dirty cement sand from entering the hydraulic system. The hydraulic oil should be changed regularly according to the manual. If it is found that the hydraulic oil is polluted by water or sand, stop the hydraulic system immediately and replace the hydraulic oil.
3.确保启用了液压油冷却器。定期清洁液压散热器,以防止其被水泥堵塞,并确保散热器风扇正常工作,并且液压温度不超过正常温度。只要保证液压部件能够清洁液压油,通常故障很少,但是制造商具有不同的使用寿命。
3. Make sure that the hydraulic oil cooler is activated. Regularly clean the hydraulic radiator to prevent it from being blocked by cement, and ensure that the radiator fan works normally, and the hydraulic temperature does not exceed the normal temperature. As long as the hydraulic components can clean the hydraulic oil, there are usually few failures, but the manufacturers have different service life.
九、搅拌和卸载
Mixing and unloading
双锥形滚筒拥有双螺旋形搅拌螺杆和中凸底部。
The biconical drum has a double spiral stirring screw and a convex bottom.
滚筒几何容量:.................... 5000L
Geometric capacity of drum: 5000L
滚筒旋转速度:..................20转/分钟.
Drum rotation speed: 20 rpm
混凝土产量:.................3.2立方米/罐
Concrete output: 3.2m3/can
“重型”球形鞍座上安装的反力架可以180°液压旋转,并且通过液压式制动器自动锁止。滚筒
 
旋转通过柱塞泵和闭路中的柱塞液压马达实现,在操作室内和搅拌机后部拥有手动电气阀。
The reaction frame installed on the "heavy" spherical saddle can rotate 180 ° hydraulically and lock automatically by hydraulic brake. The rotation of the drum is realized by the plunger pump and the plunger hydraulic motor in the closed circuit. There are manual electric valves in the operation room and at the rear of the mixer.
可拆卸溜槽可以保证直接通过料斗卸载。作为标准配置提供1个溜槽延长部件。
The detachable chute can ensure direct unloading through the hopper. A chute extension is provided as standard.
设备液压系统
Equipment hydraulic system
齿轮泵:双联齿轮泵
Gear pump: double gear pump
最大流量:.................... 90升/分钟。
Maximum flow rate: 90 L / min.
最大压力:........................ 27.5MPa兆帕,
Maximum pressure: 27.5mpa, MPa,
马达:品牌/ 美国桑尼
Motor: brand / Sonny
3件手柄多功能操纵杆。
Three handle multi-function control lever.
铝质热交换器,用于冷却液压油。
Aluminum heat exchanger for cooling hydraulic oil.
半闭式进油,可以从外部更换液压油过滤器。
Semi closed oil inlet, hydraulic oil filter can be changed from outside.
装载
load
装载臂配置自动称量感应仪,双作用装载装置举升和复位油缸,手动控制的进料口拥有标准的提示功能。
The loading arm is equipped with automatic weighing sensor, double acting loading device, lifting and reset oil cylinder, and the manually controlled feeding port has standard prompt function.
容量:.............................. 700升
Capacity: 700 liters
每次装满需要的装载次数:.......... 大约5次
Loading times required for each filling:...... about 5 times
上一条: 6.6方平口搅拌车
下一条: 最后一页

截屏,微信识别二维码

微信号:

点击微信号复制,添加好友

 打开微信