一直都有用户在反映，新的自动搅拌车买回去用久了车变得越来越重了，问怎么，那么今天我们就来说说到底是什么原因造成搅拌车越来越重的呢?出现这种情况又该怎么了?

Users have been reflecting that the new automatic mixer truck has become heavier and heavier after being bought and used for a long time. How to solve this problem? Today, let's talk about what causes the mixer truck to become heavier and heavier? How to solve this situation?

一、防止沾罐 快装快卸是关键

1、 Quick loading and unloading is the key to prevent the tank from getting stuck

随车带上减水剂

Bring water reducer with the vehicle

减水剂是一种在维持混凝土坍落度不变的条件下，能减少拌合用水量的混凝土外加剂，随车携带，能对混凝土进行很好的调节。不过在加入减水剂的时候，一定要记得有商砼站化验室的人在场，否则混凝土质量强度不够，驾驶员要承担后果。

Water reducer is a kind of concrete admixture that can reduce the amount of water used for mixing under the condition of maintaining the concrete slump unchanged. It can be carried with the vehicle and can adjust the concrete well. However, when adding water reducing agent, it must be remembered that there are people in the laboratory of commercial concrete station, otherwise the concrete quality and strength are not enough, and the driver shall bear the consequences.

回厂检查罐内水量

Return to the factory to check the water volume in the tank

每次出车任务完成回到站内的时候，检查储水罐内的水量，好让水罐中的水随时处于满罐的状态，以备不时之需。

When returning to the station after each trip, check the water volume in the water storage tank, so that the water in the water tank can be full at any time, in case of emergency.

离厂前检查混凝土质量

Check the concrete quality before leaving the factory

可能会因为原料的不同，每一盘混凝土质量都会有变化。在装好混凝土离场时，一定要检查罐内混凝土的塌落度情况以及和易度，小心混凝土的提前凝结和混凝土分层沉淀。

The quality of each plate of concrete may vary due to different raw materials. When the concrete is loaded and leaving the site, it is necessary to check the slump and workability of the concrete in the tank, and be careful of the early setting of the concrete and the layered precipitation of the concrete.

减少车辆行驶时间

Reduce vehicle travel time

混凝土运距一般在直径30范围以内，出车之前规划好路线以及车辆通行情况，尽量减少车辆在路上的时间。

The concrete transportation distance is generally within the range of 30km in diameter. The route and the traffic conditions of vehicles shall be planned before departure to minimize the time of vehicles on the road.

减少损失先卸料

Reduce losses and unload first

如果遇到人为因素或者不可抗因素，导致长时间无法卸料的情况，应随时查看罐内混凝土情况，一旦发现混凝土开始凝结。在报备负责人之后立刻进行卸料，以防整个罐体报废。

In case of failure to unload for a long time due to human factors or irresistible factors, the concrete in the tank shall be checked at any time. Once it is found that the concrete begins to set. Unloading shall be carried out immediately after reporting to the person in charge to prevent the whole tank from being scrapped.

二、自动搅拌车随时需清洗 麻烦但须做

2、 The automatic mixer needs to be cleaned at any time, which is troublesome but must be done

1.运营当中随时冲洗

1. Flushing at any time during operation

在每次卸料之后，用搅拌车自己带水枪对罐口、叶片、进料口、罐体以及犄角旮旯进行冲洗，防止混凝土凝固之后越积越多，后不好清理。

After each unloading, the tank mouth, blade, feed port, tank body and corners shall be washed with the water gun provided by the mixer truck to prevent the concrete from accumulating after solidification and being difficult to clean.

2.收车之后清洗搅拌车

2. Clean the mixer truck after receiving

每天的运送任务结束之后，在罐内加入1立方米以上的清水，快速的旋转罐体进行清洗。有条件的公司，还可以在罐内加入石子，效果会更好。

After the daily transportation task is completed, add more than 1 cubic meter of clean water into the tank and quickly rotate the tank for cleaning. Companies with conditions can also add stones into the tank, and the effect will be better.

1.控制气压 紧固接头

1. Control the air pressure and fasten the connector

罐体内应该打进多少的气压，这个在出厂的时候已经设定好，不需自己调节。如果遇上特殊情况非要调节，建议压力控制在3.5Mpa左右，压力太大容易爆管。另外，新车以及日常使用中，要对管路接口的地方随时紧固，防落。

How much air pressure should be injected into the tank? This is already set at the time of delivery. It does not need to be adjusted by yourself. If it is necessary to adjust under special circumstances, it is suggested that the pressure should be controlled at about 3.5Mpa. If the pressure is too high, it is easy to burst the pipe. In addition, in the new vehicle and daily use, the pipeline interface shall be fastened at any time to prevent falling off.

2.混凝土搅拌车加水流程

2. Water adding process of concrete mixer

每种混凝土搅拌车加水处的布置都大同小异，一般都是水罐排气——加满水——关闭加水阀;在不用的情况下，好将拨杆的位置放在中间。

The arrangement of the water adding place of each concrete mixer truck is similar. Generally, the water tank is vented - filled with water - the water adding valve is closed; When not in use, put the position of the shift lever in the middle.

3.冬季排尽管内余水

3. Drain the residual water in winter

在冬季每天收车之后应该排尽水罐内和水管中的水，并在水管打入压缩空气吹尽各个管路中残留的水，防止因为结冰造成管路冻裂。

After the vehicle is collected every day in winter, the water in the water tank and the water pipe shall be drained, and the compressed air shall be injected into the water pipe to blow out the residual water in each pipeline to prevent the pipeline from freezing and cracking due to icing.

搅拌车使用时间越久自身越重的原因就是上述所讲解的内容了，两大方面包含几个小方面的相关信息希望能够带您好的帮助，更多注意就来我们网站http://www.jfhntjbj.com咨询吧。

The longer the mixer truck is used, the heavier it is. The reason is that the content explained above. The two major aspects contain several small aspects of relevant information. I hope you can help me. Please come to our website for more attention http://www.jfhntjbj.com Consult.