In order to improve the reliability of the braking system of the automatic feeding mixer, it is suggested to improve the following parts:

（1）自动上料搅拌车制动气压管路由单管路变为双管路，以提高系数。

(1) In order to improve the safety factor, the brake air pressure pipe of the automatic feeding mixer is changed from single pipe to double pipe.

（2）增加空压机到组合阀的铁管长度，采用多个U形排列，以增强输出空气的冷却效果，装载机减轻组合阀橡胶密封件的老化。

(2) Increase the length of iron pipe from air compressor to combination valve, adopt multiple U-shaped arrangement to enhance cooling effect of output air, and reduce aging of rubber seal of combination valve by loader.

（3）采用带干燥器的调压器替换现在使用的组合阀，以减少储气罐的积水。

(3) A pressure regulator with a dryer is used to replace the combination valve now in use to reduce the water accumulation in the gas tank.

（4）自动上料搅拌车在气顶油制动系统中，加力器是非常关键的部件，对其储液罐应加装报警装置。可以采用以下两种结构：采用液位报警，使用浮子和舌簧开关以检测制动液液面的高低，适时报警；采用行程报警，若加力器活塞行程太大，说明制动系统有故障。

(4) In the air top oil braking system of the automatic feeding mixer, the booster is a very important part, and the alarm device should be installed in the reservoir. The following two structures can be adopted: liquid level alarm, float and tongue spring switch are used to detect the level of brake fluid and alarm timely; travel alarm is used. If the stroke of booster piston is too large, it indicates that the brake system is in fault.

（5）自动上料搅拌车采用液压制动系统，保留现在的盘式制动装置，去掉空压机、储气罐等装置，在液压系统中增加制动泵、调压阀、蓄能器、制动阀。

(5) The automatic charging mixer adopts hydraulic brake system, retains the existing disc brake device, removes air compressor, air storage tank and other devices, and adds brake pump, pressure regulating valve, accumulator and brake valve in the hydraulic system.

通过本文我的详解你是否对于自动上料搅拌车制动系统有多了解？如想了解更多的相关内容请关注公司网站：http://www.zkhntjbc.com后续会有更精彩内容呈现。

Through my detailed explanation in this article, do you know much about the braking system of the automatic charging mixer? For more information, please visit our website: http://www.zkhntjbc.com There will be more wonderful content in the follow-up.